Whether
you've exhausted all the usual sources for finding parts for
your outboard or sterndrive,
we can probably help. From years of experience we have
amassed an incredible network for finding
the part that has been so elusive for you to find.
We're located in Regina, Saskatchewan.
****
IMPORTANT: WE NEED TO KNOW THE MAKE, MODEL,
SERIAL NUMBER, MODEL NUMBER AND YEAR (if available). ****
We can
still get many parts for the following makes:
Chrysler /Force...Honda...Johnson / Evinrude...Mercury...Suzuki...Nissan
/ Tohatsu...Yamaha...Tools...Shop Manuals
Including Bearings ---CDI Electronics ----Connecting Rods
----Cylinder Sleeves-----Gaskets---Power Heads--
Pistons---Thermostats ---Tilt Tubes ---Trim
Motors---Starters---Water Separators---Fuel
Filters---Impellers---
Lower Unit Seal Kits ----Oil Filters
----Sleeves---Sparkplugs---Battery Cables---Bearings---Bolt
Kits---
Boyesen Reeds---Carburetor Kits---Coils---Ignition----Crank
Shafts----Cylinder Sleeves----Fuel Line / Fittings---
Fuel Pumps---Fuel Pump Repair Kits---Gasket Kits---Ignition
Switches---Lower Unit Components---Needle & Seats
---Power Heads---Power Head Rebuild Kits---Power Packs---Rod
Bolts---Connecting Rods---Skegs---
Spark Plugs / Wires----Starter
Solenoids---Stators---Thermostats---Cavitation Plates---Oil
Injection Systems---Triggers
---Grease Nuts---Shears----Tachometer----Timing Light---Volt
Meter---Plug Puller---Snap Ring Pliers---
Synchronizers---Float Gauge---Jet drills---Orifice Plug
Driver---Backlash---Bearing Remover---Bushing Remover
---Drive Shaft Tools ---Fillers---Gimbal---Hinge Pin Tools
----Nut Removers ----Pinion Nut Holder -----
Prop Wrench------Shift Shaft Bushing Tool ------Thread
Chasers ------Pressure Testers---Stands---Adapters
------Manuals---etc.
Please Note: As the parts get older and are harder
to find the price from the suppliers goes up.
Many parts are reasonably priced while others are very
pricey. I don't want to discourage you from fixing
that vintage motor,
nor do I want to discourage you from looking for that one
part you may need to get your motor running but
putting $300 out for a plastic three cylinder distributor
cap may not be the best investment considering something
else could
go wrong with the motor and you'll end up with an expensive
paper weight.
Let us find the part for you and then you can decide if you
want us to bring it in.
E-mail
us at:
jrsports@sasktel.net
Be sure to include:
MAKE, MODEL,
SERIAL NUMBER, MODEL NUMBER AND YEAR (if available)